on the same subnet) as the FPP.Ĭlick on Save, to save the definitions entered. If Multicast is specified, then the IP address is not required as the data will be broadcast to all controllers on the network (i.e. Note: The controller IP address must be on the same subnet as the FPP. If Unicast is specified, then the IP address of the controller serving that universe must be specified. You can always expand this later.įor each row, specify the Universe number, the start channel number and the number of channels (size). Accordingly, those many rows will be created in the list. Specify how many lines of Universe definitions you plan to have and Click on the Set button.Select ‘eth0’ as the E1.131 interface as normally you will be using the ethernet connection from the PI/BBB to your controllers.The ‘Enable E1.31 Output’ must be ticked if the definitions pertain to channels and universes on the PI.The Universes defined against each channel range must align with the Universes that the controller(s) are expecting and also align with the number of channels or nodes defined on each output of the controller. It is also use to define whether the FPP should use Unicast or Multicast. This screen is used to define and map the channels of ‘models’ in your sequences to Universes. It won’t have the Falcon Pixelnet/DMX tab. Note: The BBB/BBG version of the FPP has an additional tab ‘BBB’ to support controller cape definitions that are specific to the BBB/BBG including setting up the Octoscroller definitions for the P10 panel configuration.
If instead, it is the BBB version, then the following tabs are available: Note: If the FPP is the PI version, then the following tabs are available:
These can be E131, DMX, P10 Panels via an Octoscroller, Ws28xx pixels connected via a cape etc. This section is used to define how your channels map to universes in your controllers and which controller types are being used for different outputs.
FPP PHOTOFLOW MANUAL
The manual is also available by clicking the 'Manual' link at the top of the 'Help' menu in FPP. Please follow the link below to go to the current version of the FPP manual. THIS MANUAL IS FOR FPP v1.x AND IS NOW OUTDATED.
0 kommentar(er)
